outsource from india chennai india programmers freelance php coder freelance outsource scripts programming complicated perl patterns php module installation
outsource from india perl installation and configuration php installation linux system administration US$15,US$19,US$11,US$10 cheap programmer
india outsource outsource india chennai india programmers php perl mysql freelance freelance programmer
SHOWCASE of php and perl scripts CONTACT US for php custom perl scripts
HOME
 
Remote Serial Console HOWTO
PrevNext

Chapter 4. Configure the boot loader

Table of Contents
4.1. Configure the LILO boot loader
4.2. Configure the GRUB boot loader
4.3. Configure the SYSLINUX boot loader

When a PC boots the CPU it runs code from Read-Only Memory. This code is the Basic Input/Output System, or BIOS. The BIOS then loads a boot loader from the Master Boot Record of the first hard disk.[1] In turn, the boot loader reads the operating system into memory and then runs it.[2]

Neither the BIOS nor the boot loader are strictly necessary. For example, there are versions of Linux that run directly from the flash memory which usually contains the BIOS. Linux was originally designed to run without an interactive boot loader, by placing the kernel at particular sectors of the disk.

The benefits of using a boot loader are:

  • Multiple operating systems can be booted. See the Linux + Windows HOWTO for more information.

  • Parameters can be passed to the kernel interactively. This is useful for solving hardware problems; for example, some interrupt lines can be disabled, direct memory access to some drives can be disabled, and so on. See the Linux BootPrompt-HOWTO for a list of kernel parameters.

  • Differing kernels can be interactively loaded. This is useful when deploying a new kernel, as it provides simple fallback to a proven kernel.

For these reasons systems administrators want to be able to interactively control the boot loader from the serial console.

LILO, GRUB and SYSLINUX are popular boot loaders for IBM PCs. Find which of these boot loaders your Linux installation uses and then follow the instructions for your boot loader in the following section.

Notes

[1]

As usual with IBM PC/AT hardware "loads a boot loader from the MBR of the first hard disk" is a simplification. BIOS settings permitting, the MBR can be loaded from the first two detected hard disks of any controller card containing a BIOS extension. Thus the MBR can be loaded from one of the first two detected IDE disks and one of the first two detected SCSI disks.

[2]

Another simplification. A 512 byte MBR is too small to contain a program big enough to load a complex operating system. Thus most boot loaders have two stages, the first stage is located in the MBR and is only able to load the second stage of the boot loader from somewhere on a disk (such as the boot sector of the first partition). The second stage of the boot loader presents the user interface and loads the operating system.

PrevHomeNext
Optionally configure the BIOS Configure the LILO boot loader

Linux HOWTO full list
   This document, LDP HOWTO-INDEX, is copyrighted (c) 1995 - 2002 by Tim Bynum, Guylhem Aznar, Joshua Drake and Greg Ferguson. Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.1 or any later version published by the Free Software Foundation; with no Invariant Sections, with no Front-Cover Texts, and with no Back-Cover Texts. A copy of the license is available at http://www.gnu.org/copyleft/fdl.html. If you have questions, please contact the LDP.
Web Design Copyright © 1999-2003. Chrisranjana Software Solutions Pvt Ltd. syndicate rss feed